Temperature Compensation for Conductivity

The electrical conductivity (EC) of an aqueous solution increases with temperature significantly: about 2 per degree Celsius. In practice, there are several empirical formulas in use to convert measured EC values to the reference temperature at 25. But what is the physical idea behind all these equations?

The answer to this question lies in the fundamental relationship between electrical conductivity, diffusion coefficients, and the viscosity of water.

EC, Diffusion Coefficients, and Viscosity of Water

The two equations that interrelate the three physical quantities (EC, diffusion coefficient D, and viscosity η of water) are:

Nernst-Einstein equation: EC ⇔   D
Stokes-Einstein equation: D ⇔   η

The Nernst-Einstein equation states the proportionality between the EC and the diffusion coefficients Di of dissolved ions:1

(1) \(EC \ = \left( \dfrac {F^2}{RT} \right) \, D z^2 \, c \ = \ const \cdot \dfrac{D}{T}\)

where F denotes Faraday’s constant, R is the gas constant, T the temperature in Kelvin, z the electrical charge, and c the molar concentration of the dissolved ion(s).

The Stokes-Einstein equation describes the relation between the diffusion coefficient D and the viscosity η:

(2) \(D \ = \ \dfrac {k_B T}{6 \pi \, \eta \, r}\)

with kB as the Boltzmann constant and r as the “hydraulic radius” of the diffusing ion. The parameter r disappears if we take the following ratio at two temperatures T1 and T2:

(3) \(\dfrac {D_1 / T_1}{D_2 / T_2} \ = \ \dfrac {\eta_2}{\eta_1}\)

On the other hand, according to 1, EC is directly proportional to D/T which yields:

(4) \(\dfrac {EC_1}{EC_2} \ = \ \dfrac {D_1 / T_1}{D_2 / T_2} \ = \ \dfrac {\eta_2}{\eta_1}\)

If T1 refers to the water temperature T, and T2 to the reference temperature 25, then — after rearranging of 4 — the temperature compensation formula is expressed as a ratio of the viscosity of water at T and at 25:

(5) \(\dfrac {EC}{EC_{25}} \ = \ \left(\dfrac {\eta_{25}}{\eta} \right)\)

where EC and η (without the subscript) refer to the water temperature T.

Viscosity of Water as a Function of Temperature

The viscosity of pure water decreases with temperature. Typical values are:

  η20  =  1.003·10-3   kg m-1 s-1 at 20 °C
  η25  =  0.891·10-3   kg m-1 s-1 at 25 °C

A nonlinear parametrization of the dynamical viscosity is presented in the textbook of Atkins’ Physical Chemistry:2

(6)   \(\log \,\left( \dfrac {\eta_{20}}{\eta} \right) \, = \, \dfrac {A}{B}\) or   \(\left( \dfrac {\eta_{20}}{\eta} \right) \, = \, 10^{A/B}\)

with the two parameters:

(6a) A = 1.37023 (t – 20) + 8.36·10-4 (t – 20)2
(6b) B = 109 + t     and    t in °C

It describes the viscosity of water over its entire liquid range (0 to 100) with less than 1 error. [Please note that this equation refers to 20 and not to 25.]

Nonlinear Temperature Compensation of EC

Inserting 6 into 5 yields:

(7) \(\dfrac {EC}{EC_{25}} \ = \ \left( \dfrac {\eta_{25}}{\eta_{20}} \right) \,\left( \dfrac {\eta_{20}}{\eta} \right) \ = \ \left( \dfrac {\eta_{25}}{\eta_{20}} \right) \, 10^{A/B}\)

The numerical value for the conversion from 20 to 25 can be easily calculated: (η2520) = 0.889. Thus we obtain the final formula:

(8) \(EC \ = \ 0.889 \,\cdot\, 10^{A/B} \,\cdot\, EC_{25}\)

This nonlinear equation is used by the program aqion to convert EC25 to the EC at the given water temperature. The EC25 itself is calculated by the general approach based on diffusion coefficients and molar concentrations of the dissolved ions.

[Note: Although it is not obvious at first sight, 8 provides the right normalization, i.e., the ratio EC/EC25 becomes exactly 1 for 25.]

Linearization

Instead of the general, nonlinear approach in 8, linear relationships are in widespread use. The most common type of a linear expression is obtained from 8 by a Taylor series expansion (in which higher-order terms in (t – 25) are neglected):

(9) EC  =  [ 1 + a (t – 25) ]  EC25 with   a = 0.020

The mathematical derivation is presented in the appendix.

Empirical values of the parameter range are between a = 0.01 and 0.03. For example, Hayashi3 deduced a compensation factor of 0.019 from the examination of natural waters. This is in close agreement with the theoretical value:

theoretical value: a = 0.020 °C-1
Hayashi:3 a = 0.019 °C-1

Comparison of the Nonlinear and Linear Model

It is quite instructive to compare the general and linear compensation formulas. The following diagram presents EC/EC25 in the temperature range between 0 and 100:

nonlinear model —   general approach in 8
linear approx. (a=0.020) —   9 with a = 0.020
linear approx. (a=0.019) —   9 with a = 0.019  [Hayashi]

temperature correction of electrical conductivity

Obviously, at t = 25 the correction is exactly 1. This is valid for all three approaches.

Appendix: Linearization of the General Equation

We start with 8 and use the Taylor series expansion, ex = 1 + x + … . It yields:

(A1) \(\dfrac {EC}{EC_{25}} \ = \ 0.889\,10^{A/B} \ = \ 0.889\,{e^{A/B\cdot \ln 10}} \ \approx \ 0.889\,({1+ A/B\cdot \ln 10})\)

Now we simplify the ratio A/B, which is based on 6a and (6b). Ignoring all quadratic and higher terms in θ = t – 25 leads to:4

(A2) \(\dfrac {A}{B} \ \approx \ \dfrac {1.37\cdot (t-20)}{109+t} \, = \, \dfrac {1.37\cdot (\theta +5)}{134+\theta} \, = \, \dfrac {1.37}{134} \cdot\dfrac {\theta +5}{1+\theta / 134} \, \approx \, 0.010 \cdot (\theta +5)\)

That is, we get  A/B · ln 10 = 2.302 · A/B ≈ 0.023 (θ + 5). Inserting this into A1 yields

(A3) \(0.889\left\{1+ 0.023 \, (\theta +5)\right\} \,=\, 0.889 + 0.020 \, (\theta +5) \,=\, 1 + 0.020 \, (\theta -0.5)\)

Returning from θ = t – 25 to t and ignoring the small temperature offset of 0.5, gives the final expression:

(A4) \(\dfrac {EC}{EC_{25}} \ = \ 1 + 0.020 \ (t - 25)\)

This is the linear approximation used in 9.

Remarks and References

  1. For simplicity, we consider here only 1 ion (and omit the summation over ions). This does not affect the general validity of the procedure. 

  2. P Atkins and J de Paula: Physical Chemistry, 8th Edition, WH Freeman and Company New York, 2006, Table 21.4, p. 1019 

  3. M Hayashi: Temperature-electrical conductivity relation of water for environmental monitoring and geophysical data inversion, Environmental Monitoring and Assessment 96, 121-130, 2004  2

  4. Theoretically, one could go even further, and Taylor expand the denominator: (1+θ/134)-11–θ/134 + …. However, this provides hardly any increase in accuracy, so that the effort is not worthwhile. 

[last modified: 2023-11-19]